Thorens TD150 MK2 turntable Kugel cue mechanism (complete and perfectly working) Excellent clean cond Taken from late Mk2 TD150 Rare part in this condition.

Thorens TD150 MK2 turntable complete spring set to include rubbers foam washers and STRAIGHT stud set. Youll get a proper set up and bounce with these springs. Can also be used on MK1 Excellent Rare part in this condition.

As per photo.

Thorens TD150 MK2 chassis & platter. 1971, polished platter, bearing perfect.

Thorens TD150 MK2 turntable Mat and 45 rpm adaptor. Excellent Rare part in this condition.

Thorens TD150 MK2 tonearm weight. Condition is used but lovely. This is the small weight that sets tracking weight.. Very rare in this condition.

Thorens TD150 MK2 turntable control knobs. Excellent Rare part in this condition.

In working order,with TP13A tonearm and headshell(no cartridge).Aftermarket RCA plugs and cable.Includes dustcover that is damaged but does keep the dust off!Plinth is good,maybe needs a good waxing.Cash on collection preferred.Local collection only unfortunately,its too delicate to post.

Thorens TD150 MK2 tonearm weight. Condition is used but lovely. This is the large main counterweight. Very rare in this condition.

Tonearm Anti-Skating weight for Thorens TD 150 MK2 turntable. This anti skate weight is made as a close replica of the original. It is made to the correct mass value required but it my differ cosmetically to the original manufacturers weight. * Please note that this auction is for the anti skate weight and its monofilament line only. The line is knotted and has a small balancer that goes inside the weight but the end that attaches to the anti skate bar of the tonearm is open ended and therefore you must tie the loop end yourself. Length of the line supplied is 25cm which is enough extra line for a couple of attempts and I will supply extra lines if you feel you might need them for free on request. *

Thorens TD150 MK2 tonearm weight. Condition is used but lovely. This is the large main counterweight. Very rare in this condition.

Thorens TD150 MK2 turntable Kugel tonarm parts (obviously incomplete but perfectly working) Excellent clean cond Taken from late Mk2TD150 Rare part in this condition.

Thorens TD150 MK2 top plate. Condition is used but lovely with clean logos, the logos are always messed up on MK2s Very rare you see one in this condition.

ELLE FONCTIONNE LE SAPHIR DIAMANT DOIT ETRE CHANGER ON ENTEND LE SON MES FAIBLEMENT hésitée pas a me demander des renseignement VOUS ACHETEE SE QUE VOUS VOYER PHOTO FAIT PARTI DE LA DESRIPTION ENVOIE SOIGNEE ET RAPIDE MONDIALE RELAYPOUR AUTRE LIVRAISON M DEMAND2E AVANT DE PAYER POUR L ETRANGEEENVOIE DANS TOUT PAYS ME DEMANDEE POUR LES FRAIS AVANT D ACHETEE SI VOUS ACHETEE PLUSIEUR OBJET PENSSEE A LA LIVRAISON GROUPEE TOUT LES OBJET SONT SORTIE DE GRENIER IL PEUVE ETRE POUSSIEREUXLES RETOUR SONT ACCEPTER

Tonearm Anti-Skating weight for Thorens TD 150 MK2 turntable. This anti skate weight is made as a close replica of the original. It is made to the correct mass value required but it my differ cosmetically to the original manufacturers weight. * Please note that this auction is for the anti skate weight and its monofilament line only. The line is knotted and has a small balancer that goes inside the weight but the end that attaches to the anti skate bar of the tonearm is open ended and therefore you must tie the loop end yourself. Length of the line supplied is 25cm which is enough extra line for a couple of attempts and I will supply extra lines if you feel you might need them for free on request. *

Thorens TD 150 MK2 Turntable Excellent Condition Shure M55E Cart TestedIn excellent used condition and in full working order tested SME phono leads one owner from new since 1971 cost £55.00 please see photos note a couple of minor marks on perspex lid but nothing major should polish out

Tonearm Anti-Skating weight for Thorens TD 150 MK2 turntable. This anti skate weight is made as a close replica of the original. It is made to the correct mass value required but it my differ cosmetically to the original manufacturers weight. * Please note that this auction is for the anti skate weight and its monofilament line only. The line is knotted and has a small balancer that goes inside the weight but the end that attaches to the anti skate bar of the tonearm is open ended and therefore you must tie the loop end yourself. Length of the line supplied is 25cm which is enough extra line for a couple of attempts and I will supply extra lines if you feel you might need them for free on request. *

thorens td 150 mk2. Here is a link to my Dropbox for video to watch it working https://www.dropbox.com/s/p5ahf01sn2tbndt/Thorens%20Td150%20mk2%20working.mp4?dl=0

Thorens TD150 MK2 Plinth and base, the top plate is scruffy but the plinth is really nice Any questions please ask

Complete 1970s turntable, complete with the dust cover, box, SME Series II Improved arm and a contemporary Shure cartridge with a good stylus. It comes with the manuals for turntable and arm and its generally in very good condition. There is some corrosion on the arm in the form of light pitting in places but its not obvious and looks more like spots of dust. It has a fairly recent belt and has no trouble reaching 45RPM. Theres still some glue in the top lefthand corner where a dust sweeping brush was mounted. Perhaps the best solution would be to put another one there. Ive got one somewhere, let me know if youd like it. Relisted due to non-communicating, non-paying bidder. If there’s no Buy It Now price displayed, there’s no Buy It Now price Unless stated, I ship overseas. If the price isn’t shown, please ask If its not shown or mentioned, its not included Please look at my other items _gsrx_vers_1516 (GS 9.3 (1516))

Thorens TD150 MK2 turntable Mat and 45 rpm adaptor. Excellent Rare part in this condition.

Thorens TD150 MK2 turntable Kugel tonearm. Taken from late Mk2 TD150 Rare part in this condition.

Thorens TD150 MK2 tonearm weight. Condition is used but lovely. This is the small weight that sets tracking weight.. Very rare in this condition.

Tonearm Anti-Skating weight for Thorens TD 150 MK2 turntable. This anti skate weight is made as a close replica of the original. It is made to the correct mass value required but it my differ cosmetically to the original manufacturers weight. * Please note that this auction is for the anti skate weight and its monofilament line only. The line is knotted and has a small balancer that goes inside the weight but the end that attaches to the anti skate bar of the tonearm is open ended and therefore you must tie the loop end yourself. Length of the line supplied is 25cm which is enough extra line for a couple of attempts and I will supply extra lines if you feel you might need them for free on request. *