This listing consists of the following: - pair of matching genuine B&W stands with screws - pair of upper grilles - pair of lower grilles All parts were previously used with B&W DM2 MKII speakers. Despite their age, the stands are in good condition, although they do exhibit some marks as visible in the provided photos. The grilles would benefit from cleaning as they have some marks/stains. Also one upper grille has a little hole as shown on the last photo. No any cracks or other damage to any of them. Please note the marks are pictured at very bright day light so they don’t look that bad in normal room light conditions. Please take a close look at all 18 photos, and feel free to request additional close-up photos if you require more details. The stands feature M6 threaded holes on the bottom, allowing for compatibility with spikes or hard floor feet. Included with the stands are all the necessary screws for attaching them to speakers. The bases measure 33x27cm, while the speaker holding plates have dimensions of 16.5x16.5cm. If you are willing to drill holes in the bottoms of your speakers, these stands can be used with any speaker. They are designed to provide stability for heavier speakers. To ensure safe worldwide delivery, the stands will be packed with extra care. If you need any other genuine B&W parts, please don't hesitate to reach out. We may be able to assist you in obtaining them.

This listing is for a pair of matching genuine B&W stands that were previously used with B&W DM2 MKII speakers. Despite their age, the stands are in good condition, although they do exhibit some marks as visible in the provided photos. Please take a close look at all 11 photos, and feel free to request additional close-up photos if you require more details. The stands feature M6 threaded holes on the bottom, allowing for compatibility with spikes or hard floor feet. Included with the stands are all the necessary screws for attaching them to speakers. The bases measure 33x27cm, while the speaker holding plates have dimensions of 16.5x16.5cm. If you are willing to drill holes in the bottoms of your speakers, these stands can be used with any speaker. They are designed to provide stability for heavier speakers. To ensure safe worldwide delivery, the stands will be packed with extra care. If you need any other genuine B&W parts, please don't hesitate to reach out. We may be able to assist you in obtaining them.

The speakers come as shown on the photos, without front grilles or any other accessories. We can make an effort to acquire them for you at a reduced price. Please feel free to inquire. Despite their age, they are in excellent condition, with minor marks/chips visible in the photos. Both speakers are fully functional and produce incredible sound. Additionally, they have consecutive serial numbers. To ensure their safe transportation, they will be carefully packed using multi-layered cardboard, suitable for shipping worldwide. As a gesture, we may include some wires at no additional cost, depending on availability. Please don't hesitate to inquire about this when making your request. For dimensions and detailed specifications please look at the details below. High-frequency driver: a 25mm multifilament weave polyester dome unit, critically damped with PVA compounds Mid-range driver: a 100mm unit housed in a critically vented enclosure Bass Driver: housed in a critcally vented enclosure Frequency Response: 50 Hz – 18 kHz ± 3dB, at centre of listening window Sensitivity: 9 volts into 8 ohms = 85 dB at 1m Power Handling: 25 W – 200 W Dimensions (H x W x D): 710 x 270 x 330 mm